Appliance Repair Holland Nebraska

Hometown Hero Appliance Repair Rated out of 5 stars based on customer reviews

We serviced a
LG RANGE ELEC
Model LSEL6335D.BBDLLGA
Near Holland, NE 68372
Derek F
Job Details: 02/18/2025
Upon inspection the oven was having issues with the burners. I disconnected power and gained access to the switches. I replaced all 5 burner switches and the harness. I then reassembled the oven and tested each burner. The oven is operating properly.Thanks for choosing Hometown Hero Appliance Repair. Please leave us a review on Google or the link via your email for your FREE $10 gift card to Jimmy Johns. Derek!
We serviced a
WHIRLPOOL DISHWASHER
Model WDPA70SAMZ1
Near Holland, NE 68372
Ali
Job Details: 07/03/2023
During inspection unit was display a F1E1(fill) error code. Cycled the unit and confirmed it filled properly. Ran a couple of cycles with no issues. Confirmed there was no clogs within the water valve. Ran the unit in a diagnostic mode with no issues. Unit is operating properly. Ali!
We serviced a
MAYTAG DRYER
Model MEDB766FW0
Near Holland, NE 68372
Kevin
Job Details: 05/23/2023
Item stuck in felt. Removed. Now all sounds good.
We serviced a
FRIGIDAIRE DISHWASHER
Model FGID2466QF7A
Near Holland, NE 68372
Kevin
Job Details: 03/10/2023
Found. Customer said er error. And stated having issues with touch pad. Had to reset power to wake up. Got unit to run and ran through cycles ok. Need touch pad. ; dspstn on spec-tagged invntry: 1 A00126401 PUMP ASSEMBLY
We serviced a
FRIGIDAIRE REFRIGERATOR
Model FPRU19F8RFF
Near Holland, NE 68372
Ali
Job Details: 01/10/2023
"I removed old compressor and drier from unit. I then installed and welded in new compressor and drier. I then removed old fresh food evaporator and welded in new one. I then proceeded to pressurize system with nitrogen to 200 psi. I checked all welds with bubble leak detector and no leaks were found. Next I vacuumed down the system for 20 minutes and achieved a 494 micron vacuum. After removing vacuum, pump the vacuum settled out at 1598 microns. Vacuum held steady. I then recharged system with 3.5 oz of r134 ar refrigerant. Unit is now running and beginning to blow cold air. Allow 24 hours for unit to cycle temps back down to normal. Job complete.; dspstn on spec-tagged invntry: 1 297217900 HEAT EXCHGR and 1 A19676501 DRIER"