Appliance Repair Weston Nebraska

Hometown Hero Appliance Repair Rated out of 5 stars based on customer reviews

We serviced a
LG REFRIGERATOR
Model LFXS28968S.ASTCNA1
Near Weston, Nebraska 68070
Bryce
Job Details: 10/20/2025
Customer states unit is not cooling upon inspection verified complaint went ahead and put in new compressor and dryer as the fridge was upwards of 4550? in the freezer was down to 44? indicating that the sealed system is bad tapping into the system pressures were equalized put a new compressor and dryer vacuuming it down to 843 ?m filled unit with 1.94 ounces of R 600 a running pressures after about five minutes got to -.3 and 62 on the high side please allow 24 to 48 hours to reach optimal temperatures job complete.
We serviced a
WHIRLPOOL RANGE ELEC
Model WFE975H0HZ1
Near Weston, Nebraska 68070
Bryce
Job Details: 07/23/2025
Customer states unit is not heating up past 290 upon inspection verified complaint when the bait element blew. It mustve blown the bake relay as well because when trying to preheat was not going past 290 went ahead and put in new control board unit heated to 350 just fine job complete.
We serviced a
WHIRLPOOL RANGE ELEC
Model WFE975H0HZ1
Near Weston, Nebraska 68070
Bryce
Job Details: 07/18/2025
Customer states unit is not heating up passed 200 went ahead and pulled unit out and upon inspection heating element was blown put in new element unit now working properly job complete
We serviced a
SAMSUNG RANGE GAS
Model NX60A6711SG/AA
Near Weston, Nebraska 68070
Bryce
Job Details: 05/29/2025
Customer states after putting in sub PCB the error code still popped back up for the UI not working correctly upon inspection verified complaint went ahead and came back out with the touch assembly put on the touch assembly preheating unit to see if it gets over to 20 thats when the error code happened last time make sure heated past 220 unit is now good to go job complete
We serviced a
SAMSUNG RANGE GAS
Model NX60A6711SG/AA
Near Weston, Nebraska 68070
Bryce
Job Details: 05/16/2025
Customer state unit is giving the error code for the UI to not be working. Went ahead and put new UI on tried heating the unit up to 350 ended up giving the same error code the cf2 will be replacing touch assembly and holder when parts come in please contact customer to schedule ; ordrng 1 Dg61-02054a (Pcb holder) and 1 Dg94-04041a (Assy pcb) and 1 Dg96-00850a (Assembly touch)